2
PRECAUTIONS REGARDING INSTALLATION LOCATION
2
PRECAUTIONS REGARDING INSTALLATION LOCATION
2
●
This product is an indoor game machine. Do not install it outside. Even indoors, avoid installing in places men-
tioned below so as not to cause a
fi
re, electric shock, injury and/or malfunction.
- Places subject to rain or water leakage, or places subject to high humidity in the proximity of an indoor swim-
ming pool and/or shower, etc.
- Places subject to direct sunlight, or places subject to high temperatures in the proximity of heating units, etc.
- Places
fi
lled with in
fl
ammable gas or vicinity of highly in
fl
ammable/volatile chemicals or hazardous matter.
- Dusty places. Sloped surfaces. Places subject to any type of violent impact.
- Vicinity of anti-disaster facilities such as
fi
re exits and
fi
re extinguishers.
- Areas where the temperature exceeds the applicable temperature (ambient temperature) range of 5 to 30
degrees centigrade.
2-1 LIMITATIONS OF USAGE
●
Be sure to check the Electrical Speci
fi
cations. Ensure that this product is compatible with the location's power sup-
ply, voltage, and frequency requirements. A plate describing Electrical Speci
fi
cations is attached to the product.
Non-compliance with the Electrical Speci
fi
cations can cause a
fi
re and electric shock.
●
This product requires a breaker and earth mechanism as part of the location facilities. Using the product without
these can cause a
fi
re and electric shock.
●
Ensure that the indoor wiring for the power supply is rated at 15 A or higher (AC single phase 100 V ~ 120 V area).
Non-compliance with the Electrical Speci
fi
cations can cause a
fi
re and electric shock.
●
Be sure to use an independent power supply equipped with an earth leakage breaker. Using a power supply
without an earth leakage breaker can cause an outbreak of
fi
re if a power surge occurs.
●
Putting many loads on one electrical outlet can cause generation of heat and a
fi
re resulting from overload.
●
When using an extension cord, ensure that the cord is rated at 15 A or higher (AC 100 V ~ 120 V area). Using a
cord rated lower than the speci
fi
ed rating can cause a
fi
re and electric shock.
BACK SIDE
Summary of Contents for Initial D4
Page 1: ......
