Golf Bag Carrier Instructions for Installation and Operation
©2006 Segway LLC
Page 2 of 7
18592-00001 ab
Installing the Golf Bag Carrier
Step 1
Locate the Gearbox Plugs on both gearboxes.
Gently pry out all three plugs on each gearbox
using a Flathead Screwdriver. Keep the plugs in a
safe place for use in the future.
(This step is necessary only if the Golf Bag Carrier was
purchased as a separate accessory. This step is not necessary
on the Segway GT, as the Gearbox Plugs are not installed.)
Step 2
In this step you will assemble one Support and Cap
onto the Frame prior to attaching it to the Gearbox:
a.
Orient the Frame with the Warning Label facing
up. The Warning Label will be on the right side.
b.
Place one Support on the inside of the left or right
side of the Frame and insert the fittings on the
Support into the holes in the Frame.
c.
Place one Cap on the outside of the Frame and
insert the fittings on the Cap into the holes in the
Frame so that the Cap is aligned with the Support.
d.
Thread two 35mm hex fasteners with washers
through the holes in the Cap and Frame, into the
threaded brass inserts in the Support. Tighten with
a 5mm hex wrench. Torque to 7.5 N-m.
Frame
(left side shown)
Support
Cap
