Golf Bag Carrier Instructions for Installation and Operation
©2006 Segway LLC
Page 3 of 7
18592-00001 ab
Step 3
Set the assembled parts on the Segway HT so that
the Warning Label is in front of the Control Shaft
and on the right side. Align the three holes in the
bottom of the Support with the three threaded
inserts in the Gearbox.
Step 4
Thread three 18mm hex fasteners through the
Support and into the threaded inserts in the
Gearbox. Once all three fasteners are installed,
tighten using a 4mm hex wrench. Torque to 8.0 N-
m.
Step 5
Align the other Support with the other Gearbox so
that the fittings on the Support insert into the holes
in the Frame.
Step 6
Thread three 18mm hex fasteners through the
Support and into the threaded inserts in the
Gearbox. Once all three fasteners are installed,
tighten using a 4mm hex wrench. Torque to 8.0 N-
m
Step 7
Attach the remaining Cap by pushing down from
the top until the fittings on the Cap insert into the
holes in the Frame.
