2
Working with InfoKeys
Preparing an InfoKey for Programming
To prepare an InfoKey for programming, you must remove
the backplate and battery. Complete the following steps
before programming or creating an InfoKey.
NOTE:
Remove the InfoKey from any packaging.
1
If the InfoKey is powered
on, press and hold the
power/standby button
for two seconds to
power off the InfoKey.
2
Remove the InfoKey
backplate by twisting
it counter-clockwise.
3
Remove the battery to
expose the programming
connections.
Returning an InfoKey to Service
Complete the following steps to return an InfoKey to
service after programming.
1
Replace the battery, with
the positive (plus sign)
facing out.
2
Replace the backplate
by pressing and turning
clockwise.
3
To test the InfoKey, stand
no more than 15 ft. (5 m)
from your Segway PT and
press the power/standby
button .
NOTE:
Refer to the InfoKey Controller section in the
Segway Personal
Transporter (PT) i2, x2 Reference Manual for more information about
InfoKey operation.
Working with InfoKeys
An InfoKey allows a rider to control and
monitor Segway PT operation. InfoKeys
should be handled with care, and
require the procedures described in this
chapter before and after programming.
Summary of Contents for InfoKey
Page 1: ...InfoKeyProgrammingTool GUIDE 22081 00000aa ...
Page 32: ......
