Warning (cont'd)
12
13
For your safety, motor power is cut off when the miniPRO is lifted off the ground in Balance Mode. When the
miniPRO is put back down it will begin balancing again. Do not lift the miniPRO by the fenders or mainframe;
you risk pinching or injuring your fingers/hands. Please lift via the steering bar as shown above.
11
Lifting and Power Assist Mode
Lifting
Pull up the guide bar to enter Power Assist Mode (powered on, with no rider). Steer the miniPRO across
smooth surfaces using the guide bar. Do not guide it up stairs, across potholes, over large cracked/uneven
surfaces, or over other obstacles; guide your miniPRO around the obstacle or carry it over the obstacle as
shown in the previous section.
Power
Assist
Mode
Do not ride on low traction
surfaces (including, but not
limited to, wet ground, loose
sand, loose gravel, and ice).
Do not attempt stunts of
any kind. Always keep
both feet on the foot mats.
Maintain contact with the
ground at all times. Do not
jump or attempt stunts.
You must read and understand the Warnings and Safe Riding
instructions in this manual before attempting to ride the miniPRO.
10
Remote Control (R/C) Mode
You can use the Ninebot by Segway App to drive your miniPRO in R/C Mode.
1. Open the Ninebot by Segway App and connect to your miniPRO.
2. Click on the R/C icon ( ).
3. Drag the virtual joystick (the dot inside the circle) to drive your miniPRO.
WARNING
Do not use R/C mode in crowded areas or where there is a potential risk of endangering people or property
if operated in an unsafe manner. Do not stand on the miniPRO when it is in R/C mode. Doing so risks
serious personal injury or damage to the miniPRO.
NOTE
In R/C mode the default maximum speed is 4.3 mph (7.0 km/h), but you can change the max speed in the
Ninebot by Segway App. The miniPRO's Bluetooth range is 30-50 feet (10-15 meters). If your Android or
iOS device goes outside Bluetooth range, the miniPRO will stop moving in R/C mode.
