06
07
There are safety risks when learning to ride the Smart. You must read the Safety Instructions and follow
the New Rider Tutorial in the Ninebot by Segway App before your first ride.
For your safety, your Smart is not activated at this time and will beep occasionally after Power ON.
Until activated, the Smart maintains a very low riding speed and steering sensitivity, and should not be
ridden. Install the Ninebot by Segway App on your mobile device (with Bluetooth 4.0 or above), connect
to the Smart with Bluetooth, and follow the App instructions to activate your Smart and follow the training
procedures.
Scan to download the App (iOS 8.0 or above, Android™ 4.3 or above)
Remote Controller
When using the Remote Control, do not shield the antenna area; do not cover the antenna area with any part of your body.
Turn off the Remote Control and stow it in the storage compartment when not in use. Please note that the Remote Control
cannot control the movement of your Smart when in Riding Mode.
With Ninebot by Segway App, you can customize what this button does. By default
manufacturer setting, it is to enable/disable Lock Mode.
When a camera is detected, the short press is always taking photo. Press and hold for one
second is always to start recording video, and then short press to stop recording. The button
blinks blue while recording.
Camera
Following
Home
Power switch. Short press the home button to power on the Remote controller. Long press to
turn it off. The Remote controller will turn off when idle for two minute.
Home mode. Short Press the Home button tell your Smart to hold position.
Battery indicator: a. Under normal working condition, when blue LED turns normally on, it
indicates battery level above 20%; when red LED turns normally on, it indicates battery level
below or equal to 20%; when red LED flashes, it indicates battery level below or equal to 10%;
when battery level below or equal to 5%, it will automatically shut down. b. Under charging state,
The Home button LED lights on
red with breathing rhythm
, and blue for full charge.
1)
2)
3)
Move the joystick to turn on Remote Control Mode. Use the Ninebot by Segway App to
adjust
the Maximum vehicle speed.
Joystick
1)
1)
2)
Short press to Enable/disable Follow Mode. Use the Ninebot by Segway APP to adjust the
following speed and distance (from vehicle to controller).
One second long press to control the pitch and yaw position of the attached gimbal camera.
1)
2)
4
Assembling Your Segway Smart
5
First Ride
Ensure the cables are firmly connected.
1. Slide the steering bar on to the mounting bracket. Route the cable through the hole.
2. Align the tab on one connector with the notch on the other. Connect the cables.
3. Install the fasteners. Tighten securely.
4. Power on the unit for self check to ensure the cables are connected properly. The Smart beeps if the
cable is not installed correctly. Press the cap onto the steering bar until it snaps in place.
Ninebot by Segway App
1
2
3
4
Antenna Area
Camera Mode
(Customizable)
Follow Mode
Joystick
Home
