2-117
2
Basic oper
a
tion
Periodic maintenance
<Cleaning the madia edge guard>
Note
Perform the procedure below withe gloves on.
–
1
Open the front cover.
2
Dip a cleaning swab in the
cap cleaning liquid. Checking
visually, scrub stains on the
media edge guard.
3
Clean the stains with a soft and
clean cloth.
4
Close the front cover.
<Performing normal cleaning>
Select PH.REC MENU from the operation panel, and select NORMAL ALL for cleaning.
<Performing nozzle print>
Select ADJUST MENU from the operation panel, and select TEST PRINTS to perform the
nozzle print.
Check for nozzle-out and incorrect print. The nozzle print is also used to check the print
head before the first print everyday or after the head is moved out of the capping unit for
cap cleaning. If nozzle-out is found in the nozzle print, perform the normal cleaning.
Note
Do not leave the print head outside the capping unit. Finish the nozzle print
within five minutes and cap the print head. After the nozzle print is completed,
perform normal cleaning for the print head.
–
