3-40
(15) BACK ADJUST VAL
Set the back adjust value of media. This value is
used to correct the splice of two images divided by
the auto-cleaning (PH CLEANING [DURING PRINT]
performed during printing.
# B A C K A D J U S T V A L
> X X : + 0 0 0 0 P U L S E
XX: Selected media number
<Parameter (numeric input)>
±2000 pulses (Unit: Approx. 3.5 μm)
(16) PH REST PERIOD
Scanning of the print head rests at every certain
print length during printing. Set this time period to
prevent nozzle-out of the print head. Normally, set
it to [0000CYCLES].
# P H R E S T P E R I O D
> X X : 0 0 0 0 C Y C L E S
XX: Selected media number
Set the number of scans for print length in [(16) PH REST PERIOD].
–
<Parameter (numeric input)>
0000 to 9999 Setting [0] does not perform the scan rest.
(17) PH REST TIME
Corresponding to
[(16) PH REST PERIOD]
, set the
scan rest time. When [0] is set for
[(16) PH REST
PERIOD]
, this parameter is ignored. Set this rest
time to prevent nozzle-out of the print head. Set it
to [10 sec] as a rule of thumb.
# P H R E S T T I M E
> X X : 1 0 s e c
XX: Selected media number
<Parameter (numeric input)>
1 to 99 seconds
Set the rest time in [(17) PH REST TIME].
–
