4-3
4
P
rin
t mode and special prin
ting
Print mode and special printing
*1
The values indicate the speed to print on 2.5m-width roll media across the full width.
The former value indicates the 8-color print speed, and the latter, the 4-color one.
*2
The max. print density shows a reference for the max. print density obtained by the printer.
With the actual print, density is obtained by the RIP profile's color management.
At DENSITY2 mode for backlit media, normally the whole image is printed with a slightly
high density.
At the other modes, the image is printed as follows.
- The image such as photo is printed with the same density.
- The solid-painted part's density may differ depending on the RIP setting.
*3
Your RIP software may display "STANDARD1" instead of "NORMAL1."
*4
Your RIP software may display "STANDARD2" instead of "NORMAL2."
We recommend the NORMAL1 print mode. Use other modes when you emphasize
productivity and/or print quality.
–
Double-sided printing
This printer allows printing on both sides of media.
(
P.4-4)
Mesh banner printing
This printer allows printing on mesh-type banner without liner.
–
–
–
–
