4-4
For convenience of explanation on the double-sided printing below, the side printed
first is referred to as "first side" and the side printed next is referred to as "2nd side." The
following procedure is described for the case to print the first side of the media, reinstall
the media to the roll feed unit for each scroller that mound the media, and then print the
2nd side of the media.
First-side printing
2nd-side printing
Move
Scroller moves
1
Install the media.
For how to install media, refer
S E L E C T M E D I A
R O L L / S H E E T : F A C E
to
P.2-7 "Media installation and removal."
At this time, choose
"FACE" with the
or
key for media selection.
Note
When using banner (with different undulations on the first and 2nd sides) for
single-sided printing, print the side with more undulations first regarding it as
"first side."
–
2
Install the media to the take-up reel unit.
For how to install media to the take-up reel unit, refer to
P.2-16 to P.2-21
"Procedure to install general roll media to the take-up reel unit."
Since a margin of approximately 2.5 m or more is required for the 2nd-side
printing, wind about 4 turns of media to the take-up reel unit in advance.
3
Start printing on the first side of the media.
Double-sided printing
