2-16
Procedure to install general roll media to the take-up reel unit
For the procedure for attaching the vinyl chloride roll media to the winding device, please
refer to "Procedure to load PVC (Vinyl Chloride) roll media on TUR in LOOSE winding
mode>" on page 2-22.
1
Adjust the roll spacer position according to the media width.
The roll spacer prevents the paper tube from bending at the center due to the
media weight.
–
Roll spacer
Scroller
Do not move this roll spacer.
(1) Remove the two screws and move
the roll spacer to the center of the
media. There are three screwing
positions.
2
Prepare a paper tube and attach it to the scroller.
Handle
Paper setting gauge
Paper tube
Flange
Attach the paper setting
gauge’s flange side to
the flange’s spoke side.
(1) Determine the distance between
the paper tube edge and the flange
using the paper setting gauge, and
secure the flange by rotating the
handle.
