30
(3) A message of mode selection is printed as shown in Figure 10-5 when the test print has completed.
To print Wireless LAN information, select "4 : Print WLAN Information". (Press the FEED Switch 4
times, and then press the POWER Switch.)
The printer starts preparation for printing Wireless LAN information.
Figure 10-5 Mode Selection Message (Wireless LAN Model)
(4) The information acquisition message in Figure 10-6 is printed until the printing of Wireless LAN
information starts.
Figure 10-6 Wireless LAN Information Acquisition Message
After completing acquisition Wireless LAN information, Wireless LAN information is printed as a
sample shown in Figure 10
Figure 10-7 Wireless LAN Information Print Example
[Mode Select]
0 : Normal Mode
1 : Setting Mode
2 : Wireless ON/OFF Mode
3 : Hex Dump Mode
4 : Print WLAN Information
Press the FEED switch an equal
number of times to the selected number.
After that, press the POWER SW.
Getting WLAN information. Please wait...
* WLAN Communication *
Mode: Simple AP
Radio: 802.11b/g/n
Country: US
Channel: Auto
SSID: SII-Printer
Security: None
MAC Address: XX:XX:XX:XX:XX:XX
IP Address: 192.168.0.1
Subnet Mask: 255.255.255.0
Default Gateway: 0.0.0.0
Module Ver.:
XX.XX
