Large end of pan
connector can
be trimmed to
suit setout.
Threaded
section can
be trimmed to
required size.
cistern package contents
1 x ceramic cistern lid
1 x ceramic cistern base
containing:
1 x flush valve
1 x bottom entry inlet valve
Cistern is supplied with
flush valve and Bottom
Entry inlet valve already
installed. See Diagram a.
2 x bolts w seals
For attaching
cistern to pan.
1 x plug
Only required if
installing back
entry (BE) version.
1 x rubber seal
For sealing outlet at
base of cistern.
1 x flush button
Optional with BE versions:
1 x back entry inlet valve
Note: This component is only
supplied with Back Entry
versions.
pan package contents
1 x ceramic pan
1 x pan connector
For connecting pan to
floor outlet pipe/S-trap.
1 x threaded section (with
flange plate)
Flange attaches to wall;
threaded section links to
pan connector.
2 x concealed fixing
brackets
Optional — can be
used to connect pan
to floor.
2 x floor bolts
(+ white plugs)
2 x washers
Optional fixing #2 — used
with fixing brackets
to secure pan to floor.
Bolt is inserted through
bracket base hole.
2 x caps (chrome plated)
2 x screws
2 x pan plugs (white)
Optional fixing #2 — used to
secure pan to concealed fixing
bracket. Plastic plug is placed
into hole in side of pan exterior,
screw is rebated into plug
and then screws into a hole
in upright section of bracket.
Chrome cap is used to cover
plastic plug.
Cistern comes
with flush valve
and Bottom Entry
inlet valve already
installed.
seat package contents
1 x seat and lid
Has receptor holes that slide onto stainless steel pins.
2 x stainless steel caps
(used to cover stainless steel plate w pin)
2 x stainless steel plates with pin
(seat locates onto stainless steel pins)
2 x toggle bolts
(used for securing stainless steel plate and pin to pan)
important
1
Inspect the components before installation to ensure there are no visible defects. If a defect is found, do not install the toilet suite and contact the
supplier immediately. Claims for defects will not be accepted after the product has been installed.
2
This toilet suite is suitable for a variety of set-ups:
Cistern — accommodates either Bottom Entry Inlet connection (left or right stop valve) or Back Entry Inlet connection.
Pan — universal trap — accommodates S-trap installation or P-trap installation (using appropriate connector; not supplied).
3
The toilet suite must be installed by a licensed plumber. Failure to do so may void the warranty.
4
Installation must be in accordance with aS/NZS3500.
INSTALLATION GUIDE
limni
sto-301
+
mAXim
sto-302
Page 2 of 4 | seima.com.au
