Seip UK 100, Installation Instructions Manual

Remote Control Set

Installation Instruction UK 

 -  

Page 7

Receiver

Codification-block

The receiver is fixed on the electric board. Besides
you find the codification block with 12 switches.

1-channel hand-transmitters

Opening a 1-channel hand-transmitter as shown on
the drawing besides, you will find the same
codification block as the one for the receiver. You
may adjust all 12 switches as you like. Be careful
not to put all switches onto ON or OFF and make
sure you have the same code on both,
hand-transmitter and receiver. (The ON written on
the codification block shall help you to orientate).

More-channel 

hand-transmitters (up to

4-channel)

Inside a more-channel hand-transmitter you will find
a codification block with 10 switches. On these you
may adjust any code you like. Make sure not to put
all switches onto ON or OFF.

The switches 1 to 10 on the receiver-codification
block must be adjusted like in your
hand-transmitter.

The subscription on the bottom of this page shows
you how to use the switches 11 and 12 on the
receivers codification block. For example you might
have two or three operators you wish to control with
only one hand-transmitter. In that case you will
have to use a two- or a three-channel
hand-transmitter. The codification of the switches 1
to 10 will be the same in all components (all the
receivers and all the hand-transmitters). Only the
switches 11 and 12  will be adjusted different on
each of the used receivers, dependent on which
button of your hand-transmitter you want to use for
which operator.

Transmission range:

There is no fixed rule how to reach the maximum
transmission range.  The range will be influenced
by:
- building-materials used for the garage
- surroundings of the garage
- area

In some garages it might not even be necessary to
unroll the antenna, in others you might not reach a
high distance without extensioning the antenna. Try
putting the antenna into different directions (into the
back, into the front, to the side of the garage) and
choose the position where the result is the best.

Avoid putting the antenna into contact with
metal or electrical wires.

Trying the remote-control set make sure not to be
too close to your operator (a minimum distance of 4
m should be held) otherwise you might overpower
the receiver, what will not cause a damage but 

the

remote-control just might not work on that
short distance!

Button 2

Button 3

Button 4

Button 1

Adjustment of the switches 11 and 12: 
on the receiver codification block:

Codification block

Batterie