~
Power failure?
~
Disconnect and connect receiver.
~
Is the door stuck because of snow and ice?
~
Check the lines and the connections of the push-button switch.
~
Is there water in the push-button switch or in the key operated switch?
~
Check the line of the push-button switch.
~
Does the push-button switch work, when the receiver is disconnected? If so, your
transmitter is defective.
~
Check the accordance of the transmitter and the receiver code.
~
Displace the antenna of the receiver. Avoid each metal contact (reduces the range).
~
Check the battery of the transmitter
~
Change the code of your remote control (of transmitter and receiver).
~
Disconnect the receiver or remove the transmitter battery. Use your push-button switch
only. If this solves the problem, your sender may be defective.
~
Disconnect the push-button switch and use your transmitter only. If this solves the
problem, the push-button switch or the line of the push-button switch may be defective.
~
Is the limit switch "OPEN" correctly set?
~
Is the door jamming while opening?
~
Unlock the carriage manually (make the door running well). Lubrificate and oil the pivotal
points of the door.
~
Increase the power for the OPENING direction
~
Is the limit switch "CLOSE" correctly set?
~
Is the door jamming while closing?
~
Unlock the carriage manually (make the door running well). Lubrificate and oil the pivotal
points of the door.
~
Increase the power for the CLOSING direction
~
Is the limit switch "CLOSE" correctly set? If not, your opener switches off under
pressure. In this case the chain is under tension and therefore the emergency release
can hardly be unlocked. Make sure that the limit switch is correctly set, otherwise your
opener can be damaged.
~
Replace the bulb (24 V, E14, max. 15 Watt)
~
Unlock the carriage of the opener. Move the door manually and make sure that the door
is well balanced (must come to a stop at each position).
~
The spring tension is too high or there is even a spring fracture.
~
The door is jamming.
~
The carriage is unlocked. If you want to lock it, open the door, but not completely, and
let the opener run. The carriage locks automatically.
~
Unlock the carriage with the help of the emergency relese and open the door manually.
(If you have a garage where you can only enter from outside: Unlock the door with the
key and turn the door-handle, then your opener will be unlocked.
If you have a garage where you can also enter from inside: pull at the Bowden cable
hanging from your carriage.)
Problems? No problem....
The opener reacts on
the transmitter but not
on the push-button
switch.
The emergency release
doesn´t work very well.
The door opens and
closes without order.
The door doesn´t close
completely and opens
again.
The opener doesn´t
react on the transmitter
nor on the push-button
switch.
The opener works, but
the door doesn´t move.
The opener reacts on
the push-button switch
but not on the
transmitter
The opener doesn´t
work because of a
power failure.
The motor is buzzing
but the door doesn´t
move.
The opener isn´t
running well.
The door doesn´t open
completely.
The light doesn´t go
on.
Summary of Contents for UK 100
Page 9: ...Problems No problem...
