26
PROBABLE REASON:
Due to an extremely low consumption of electricity in
the circuit, if the batteries had already been inserted
recently, it is possible that a small amount of energy
is still present even if there is no power supply,
therefore the thermostat momentarily behaves as if
the batteries had not been removed at all.
REMEDY:
Press the internal test button
4
for a second to reset
the internal electronic circuits.
SYMPTOM:
When the batteries are inserted, also by pressing the
“Test” button
4
, the LED does not come on for 2
seconds, briefly flashes and the thermostat doesn’t
work.
PROBABLE REASON:
The batteries are dead.
REMEDY:
Correctly insert new batteries.
The “Installation” paragraph explains how to perform
the operation correctly.
SYMPTOM:
In the “Test” mode, the LED
9
in the thermostat
flashes correctly, but the relay of the relative
output in the receiver still remains off.
PROBABLE REASON:
The address code of the thermostat hasn’t been
correctly self-learnt by the receiving unit or the
self-learning procedure hasn’t been carried out on any
of the unit’s channels.
ENGLISH
PORTUGUÊS
DEUTSCH
ITALIANO
FRANÇAIS
ESPAÑOL
NEDERLANDS