2
. Attach the riser assembly to the front of the
hood rack and bolt the (2) front riser caps in
place. Snug the cap bolts, but keep them loose
enough to allow rotation.
3
Hood Rack Pre-Assembly
Locking Bolt
1
. Note the riser orientation shown above. Insert the (2) Riser stems (C) into the front riser/light mounting
Plate (D) a few inches in. Tighten the locking bolt at the top of the tube with allen wrench just enough to hold the
riser stems in place. You will tighten after final assembly.
3
. Attach the two clamps (E) to the roll cage
clamps (G) with two M6 x 16mm socket head
bolts, 4 washers and 2 nuts. The clamp lever
should open towards the front of the vehicle.
Front of Vehicle
4
. Attach the two clamps (E) to the bumper mount (F)
using (4) M6 x 16mm bolts, (2) washers and (4) locknuts.
Make sure all clamp levers open towards the front of the
vehicle.
Front of Vehicle
1
2
To open a clamp, lift up on both levers in the order
above. Orient all clamps so the first clamp lever
opens towards the front of the vehicle. To increase
clamping force, tighten screw; to decrease the
clamping force, loosen screw before locking.
Adjust screw
for clamping
force
NOTE: Clamp Orientation and adjustment
Front of Vehicle
