0000136904
rev. 2.0
6
Alarm
Display
Relay
Actions to do
Level
level____7,2_ph
Alarm Relay Close - Push Enter Key to open
Alarm Relay
- Restore Product tank
OFA First Alarm (time >70%)
ofa_alarm__7,2_ph
Alarm Relay open
- Push Enter Key to reset
OFA Second Alarm (time =100%)
ofa_stop___7,2_ph
Alarm Relay Close - Push Enter Key to reset
Flow Rate
Flow_______7,2_ph
Alarm Relay open
- Restore Flow Rate
System Error
Parameter_error
Alarm Relay Open - Press Enter Key to replace
Default parameter
- Destroy Unit
Calibration Function
Error_7_ph
Error_4_ph
Error_465_mv
Alarm Relay open
- Restore Probe or Buffer
solution and repeat calibration
function
To restore Default parameters run Following steps:
•
Power off Pool Basic unit
•
Keeping Press UP and DOWN Key switch on the
Power.
•
The unit will flash
Init.default__no
•
Press up
Init.default__Yes
•
Enter Key to restore Default parameters.
Default parameters:
•
Language =
UK
•
Set Point value=
7,4 pH; 750 mV (Rx)
•
Dosing Method =
Acid; Low (Rx)
•
Time OFA =
OFF
•
Calibration =
Full
•
Flow Input=
OFF
•
Type dosing=
PROP
set
esc
enter
cal
prog
