0
SR-1800
SW2-5:
Select automatic sheet discharge. When it is ON (factory setting) and an error
related to automatic sheet discharge (see below) occurs, the sheet will be
discharged automatically.
(This function becomes effective when the setting for SW3-3 Sheet Hold is ON.
The factory setting is OFF.)
List of Errors for Automatic Discharge:
Error
Automatic discharge
Sheet empty
×
Timing mark error
○
Double feed error
○
Edge skew error
○
Mark skew error
○
Sheet jam or sheet remaining
×
Other error
○
○
:Automatic discharge on
×:Automatic discharge off
SW2-6:
Select sheet empty detection. When it is ON and a “sheet read command” is
received, it will detect the absence of sheet if there is no sheet in the hopper.
The factory default setting is OFF (absence of sheet will not be detected). The
factory setting is OFF (absence of sheet will not be detected).
SW2-7:
If there are three or less timing marks on the sheet that was read, a timing mark
error will be detected (detection is made as the factory setting is ON).
