Date Code 20020501
SEL-421/SEL-421-1 Relay
CAUTION:
Equipment components are sensitive to
electrostatic discharge (ESD). Undetectable permanent
damage can result if you do not use proper ESD procedures.
Ground yourself, your work surface, and this equipment before
removing any cover from this equipment. If your facility is not
equipped to work with these components, contact SEL about
returning this device and related SEL equipment for service.
!
CAUTION:
There is danger of explosion if the battery
is incorrectly replaced. Replace only with Ray-O-Vac
®
no.
BR2335 or equivalent recommended by manufacturer. Dispose
of used batteries according to the manufacturer’s instructions.
!
DANGER:
Disconnect or de-energize all external
connections before opening this device. Contact with
hazardous voltages and currents inside this device can cause
electrical shock resulting in injury or death.
!
DANGER:
Contact with instrument terminals can
cause electrical shock that can result in injury or death.
!
WARNING:
Use of this equipment in a manner other
than specified in this manual can impair operator safety
safeguards provided by this equipment.
!
WARNING:
Have only qualified personnel service this
equipment. If you are not qualified to service this
equipment, you can injure yourself or others, or cause
equipment damage.
!
WARNING:
This device is shipped with default
passwords. Default passwords should be changed to
private passwords at installation. Failure to change each default
password to a private password may allow unauthorized access.
SEL shall not be responsible for any damage resulting from
unauthorized access.
!
ATTENTION:
Les composants de cet équipement
sont sensibles aux décharges électrostatiques (DES). Des
dommages permanents non-décelables peuvent résulter de
l’absence de précautions contre les DES. Raccordez-vous
correctement à la terre, ainsi que la surface de travail et
l’appareil avant d’en retirer un panneau. Si vous n’êtes pas
équipés pour travailler avec ce type de composants, contacter
SEL afin de retourner l’appareil pour un service en usine.
!
ATTENTION:
Il y a un danger d’explosion si la pile
électrique n’est pas correctement remplacée. Utiliser
exclusivement Ray-O-Vac® No. BR2335 ou un équivalent
recommandé par le fabricant. Se débarrasser des piles usagées
suivant les instructions du fabricant.
!
DANGER:
Débrancher tous les raccordements
externes avant d’ouvrir cet appareil. Tout contact avec des
tensions ou courants internes à l’appareil peut causer un choc
électrique pouvant entraîner des blessures ou la mort.
!
DANGER:
Tout contact avec les bornes de l’appareil
peut causer un choc électrique pouvant entraîner des
blessuers ou la mort.
!
AVERTISSEMENT:
L'utilisation de cet appareil
suivant des procédures différentes de celles indiquées
dans ce manuel peut désarmer les dispositifs de protection
d'opérateur normalement actifs sur cet équipement.
!
AVERTISSEMENT:
Seules des personnes
qualifiées peuvent travailler sur cet appareil. Si vous
n’êtes pas qualifiés pour ce travail, vous pourriez vous blesser
avec d’autres personnes ou endommager l’équipement.
!
AVERTISSEMENT:
Cet appareil est expédié avec
des mots de passe par défaut. A l’installation, les mots de
passe par défaut devront être changés pour des mots de passe
confidentiels. Dans le cas contraire, un accés non-autorisé á
l’équipement peut être possible. SEL décline toute
responsabilité pour tout dommage résultant de cet accés non-
autorisé.
!
Schweitzer Engineering Laboratories, SEL
OGIC
, Connectorized, Job Done, SEL-PROFILE,
AC
SEL
ERATOR
, and
are
registered trademarks of Schweitzer Engineering Laboratories. All brand or product names appearing in this document
are the trademark or registered trademark of their respective holders.
The software (firmware), schematic drawings, relay commands, and relay messages are copyright protected by the
United States Copyright Law and International Treaty provisions. All rights are reserved.
You may not copy, alter, disassemble, or reverse-engineer the software. You may not provide the software to any third
party.
The information in this manual is furnished for informational use only and is subject to change without notice.
The English language manual is the only approved SEL manual.
This product is covered by U.S. Patent Numbers: 4,996,624; 5,041,737; 5,317,472; 5,325,061; 5,349,490; 5,365,396;
5,367,426; 5,479,315; 5,515,227; 5,652,688; 5,694,281; 5,703,745; 5,731,943; 5,790,418; 5,793,750; 5,883,578;
5,914,663; 6,028,754; 6,084,755; U.S. and Foreign Patent(s) Pending.
This product is covered by the standard SEL 10-year warranty. For warranty details, visit www.selinc.com or contact
your customer service representative.
ã
2001, 2002 Schweitzer Engineering Laboratories. All rights reserved.
PM421-01
Summary of Contents for SEL-421
