OPERATING MANUAL
28
A twisted cable goes through the arm, connecting the antenna with the power and control
units housed in the main body. Fig. 6 shows the device with the arm retracted, and fully extended.
Fig. 6
1.6.4. Controls
Three control buttons are at the front of the handle (Fig. 7).
The mode-setting button (2, Fig. 7) is marked with an
.
A short press of this button alternates between SEARCH
and AUDIO; holding it down for a few seconds will set the
device to the ADAPT mode.
The other two buttons marked and (1 and 3, Fig. 7)
are for tuning the device. Depending on the mode, they allow:
– in the SEARCH mode, increasing and decreasing the receiver
sensitivity, respectively.
– in the AUDIO mode, setting the desired frequency
combination.
Fig. 7
2. USE
2.1. Preparation
Take the device and rechargeable batteries out of the case. Examine the main unit, antenna, cable
and socket for mechanical damage. Examine the batteries for mechanical damage and electrode
corrosion. Do not use the device if any such defects are found!
To replace the batteries, do the following:
•
unscrew the battery compartment cap;
•
insert two accumulator batteries as shown in Fig. 8, making sure you observe the polarity;
•
screw the cap back in place.
