19
3.
Press the line drum halves together around
the lower bearing assembly. The oval flange
must align with the cut-out in the lower bea-
ring assembly. Check that both connector clips
engage properly.
4.3 Fitting the line drum and line guide – 200 TD & 300 TD
The line drum consists of two halves. It is easier to fit after the Furlex stay is fitted to the mast.
1.
Feed the furling line through the hole in the line
guide fitting and then through the hole in the
line drum half which has a clip fitted.
2.
Undo the clip and insert the line into the
oval space as shown in the diagram.
Fasten the clip securely, but do not over-
tighten!
Fig. 4.3.a
Fig. 4.3.b
Cont. on page 26.
Slide the line guide fitting in the line guard from
below and swing it up into the position. Tighten
the screws
in the stainless steel line guard
housing.
Slide the line guard on from aft and turn it half
a revolution as per fig. 4.3.d. Press the locking
block in from underneath (arrow 2) so that it
"clips" firmly into place.
Fig. 4.3.d
4
5
2
1
2
1
2
Fig. 4.3.e
Fig. 4.3.c
Summary of Contents for Furlex 200 TD
Page 23: ...23 Notes Comments...
