INSTRUCTION MANUAL CODE 80303 REV B
Sep2019
(It can be modified without notice) Page: 20
J
.P. SELECTA s.a.u. Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España Tel 34 937 700 877 Fax 34 937 702 362
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
8.9 Information. Firmware update.
The equipment is tested and checked before shipment but there may be impro
-
vements in the control operation.
If it is necessary to update the firmware version, press the
INFORMATION
option and Fig 8.9 appears.
Press the
UPGR
key and follow the instructions that appear on the
screen. A screen similar to Fig 8.9.1 will appear.
To obtain the file with the update, it is necessary to know the
DEVICE ID
code
that appears in screen Fig 8.9. Load this file into a
USB
memory and insert it
into the front connector.
Attention: during the update process DO NOT turn off the equipment or remove
the
USB
memory from the connector. The equipment could run out of control.
The update process lasts a few minutes. During the update process the control
is turned off several times, but this is normal.
Press the
BACK
key to return to the settings menu or the
HOME
key to return
to the initial screen.
8.10 Information about connection to data network
From the
INFORMATION
menu you can query communication data to a data
network.
Press the
NET
button to see this information.
Press the
BACK
key to return to the settings menu or the
HOME
key to return
to the initial screen.
Fig. 8.9.1 Firmware update
Fig. 8.9 Information screen
Fig. 8.10 Information about connection to the
data network
