INSTRUCTIONS MANUAL
CODE 80381 REV C
12/2020
Pag.: 23
J
.P. SELECTA s.a.u.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
e-mail:selecta@jpselecta.es - web site: www.jpselecta.es
Log
The equipment can store readings from time to time and store them
lately in a USB memory pen.
«PORT»
Set the readings storing mode:
• USB:
Store the readings in a USB memory pen drive.
«INTERVAL»
Select the log time interval of a data, with the keys
«MODE»
Select the data to be stored:
• Start:
Save all temperature readings.
• Set point:
Save temperature readings, since the set point tem
-
perature has been reached.
«USB»
Update the firmware from a file that is in a USB.
Temperature
It is recommended to verify calibration of temperature with some regu
-
larity (for example, annually), by using for instance a thermometer or
a temperature pattern.
If it is necessary to correct the reading, as a result of calibration, one
must enter a correction. To do this, select CORRECT T.
A box indicating the current correction value appears.
Adjust with keys
until the you get the indicated value on the
temperature pattern. Applied correction will appear in brackets.
Temperature alarms
By pressing successively on the temperature correction box, one may
enter an over-temperature (
Alm sobre T
) and low-temperature (
Alm
bajo T
) limit. Both alarms activate a message on screen.
T.S. settings
This parameter sets the maximum value of the electronic safety ther
-
mostat, it is recommended to leave it at its maximum value. It activates
a message on the screen.
Comp. ON
Adjust the operating time of the compressor.
Comp. OFF
Adjust the compressor shutdown time.
RET.VET
Adjust the delay of entry into operation of the indoor fan.
Tª INI COMP
Adjust the temperature from which the compressor stops working.
Units
Press on the Units menu. Press successively to change between Celsius
or Farenheit degrees.
Language
Press on the Language menu. Press successively on the box to select
among Spanish, French or English.
Adjust by pressing on the increase and decrease icons.
TEMPERATURE SETTINGS MENU
LOG MENU
USB
PORT
No save
TIME
0
USB
Start
MODE
CORRECT. T
(0) 37ºC
CORRECT T
ALARM BAJO T
0.0 ºC
ALM BAJO T
ALARM SOBRE T
0.0 ºC
ALM SOBRE T
CORRECT. T
inf
COMP. ON
ALARM BAJO T
30 ºC
Tª INI COMP
ALARM SOBRE T
- - - -
COMP. OFF
ALARM SOBRE T
80ºC
AJUST T.S.
ALARM SOBRE T
- - - -
RET. VENT.
