MANUAL DE INSTRUCCIONES
CODIGO 80073 REV E
09/2021
Pag.: 13
J
.P. SELECTA s.a.u.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
e-mail: selecta@jpselecta.es - website: http://www.grupo-selecta.com
OPERATION
CONTROL PANEL:
1. Main switch.
2. Handling knobs for each place.
3. Power regulator knob (*)
4. Heating element operation indicator lamp (amber) (*)
* For stirrers with heating.
Do not use the autoclave if it is not earthed.
Make sure that the voltage indicated on the description
plate coincides with the mains power.
If you have to change the plug, bear in mind the following:
Blue cable: Neutre.
Brown calbe: Phase.
Green/Yellow cable: Earth.
STARTING UP
* For stirrers without heating (Models S)
- Press the main switch (1).
- Place the vessels to be stirred on the engraving places.
- Introduce a teflon stirring bar in each vessel.
- Turn each handling knob (2) clockwise to reach the desired
speed.
* For stirrers with heating (Models N)
- Follow the above mentioned indications.
- With the power regulator knob (3), adjust the heating ele-
ment operation cycle of the hotplate. The indicator lamp (4)
will light up.
2
1
4
3
