19
The Following is for experienced users already familiar with the full flying procedures of the FARM EYES. As per the user
agreement ensure all manuals have been read and understood in full. If any part of this procedure differs from your
experience consult the manual and then seek technical assistance if not resolved.
All batteries should be fully charged,
No parts should be damaged, all parts should be fitted firmly
Controller
(Transmitter)
•Connect 3S Battery to LCD Display and power on
•Screen should apear as static or plain blue with text “No Signal”
•Switch on Radio controller confirmed by beep sound and
Blue
light
Hexacopter
•Connect 4S Flight Battery to Hexacopter
•FARM EYE's undergoes start up procedure then Radio receiver should sync with transmitter and glow
constant
Orange
Camera
•Fit AV-out cable to the camera(s USB socket)
•Power on the camera
FPV (First
Person View
)
•Connect the 2S battery to the power both the Gimbal and Video Transmitter (through the Power Y splitter
cable)
•Camera view should appear on the LCD display, gimbal will activate and begin image stabalising
•If desired start the camera recording (requires micro SD card)
Ready for
Flight
•Provided no errors or sensors indicating problem the Hexacopter (UAV) should be ready to arm the rotors
•Check GPS status light to confirm signal, if signal is low before takeoff the accuray of the return to home
position maybe of low accuracty. Set controller SW2 switch to position 1 (GPS Loiter /Assist)
•Recheck for people, animals or potential obstables above or nearby if safe to proceed to disarm the rotors
confirmet by the status light.
•Take note of the time when starting flight (or use the camera recording time diplayed on LCD screen) to
ensure that flight duration does not exceed battery capacity.
•Arm the rotors so the indicator light changes to a solid
●●●●
Red/pink light then apply throttle while
rotors armed or other wise rotors will automatically disarm for safety (
●
●
●
●
●
●
).
Start up and Flying: Quick Start Procedure
Once landed allow the motors to disarm (Confirmed by the Flight controller indicator.
1.
Disconnect the 4S Flight battery, stop the camera recording (if recording).
2.
Disconnect the 2S battery stopping the Gimbal and 5.8G transmitter
3.
Turn off camera
4.
Disconnect 3S battery power from LCD Viewing Screen and power off the controller.
5.
Check all parts for damage repair where required.
6.
Check for any loose components and tighten as necessary
Post-Flight Procedure
