4
Ensure you have read and understood this manual and all other support documentation in its entirety
before attempting to operate or install
Read and take note of all following safety warnings and notices.
Failure to comply with these warnings may result in serious injury or death.
Warning !
This product is highly technical, although it has functions to allow for easier flying this product is not a toy and absolute
caution must be used to avoid damage to the equipment and people and animals.
Warning !
Never allow an inadequately trained person to install or operate. We recommend that you seek the assistance of an
experienced pilot when flying for the first time.
Warning !
Operator miss-operation may cause severe damage or injury to people or property and is the responsibility of the operator.
Warning !
Ensure that all operators and associated personnel are familiar with the legal regulations and codes of practice that apply to
usage. CASA (Civil aviation safety authority) is the main regulatory body and we suggest your review www.casa.gov.au for
your initial regulatory information for flying a RPA (remotely piloted aircraft).
Warning !
Always keep a safe distance in all directions around the UAV to avoid collisions or injury. This UAV is controlled by a radio
signal subject to possible interference or obstruction outside of your control that may cause momentary loss of control.
Warning !
Always keep transmitter powered on while aircraft is powered and never operate with low batteries.
Warning !
This product should never be left unattended and must always have an active and attentive operator whenever the UAV is
powered on.
Warning !
Always, disconnect all batteries when not in use and remove from the UAV, Always remove batteries before disassembly.
Warning !
This product and its accessories utilise Li-ion and/or LiPO type batteries that must be maintained and cared for. Miss-handling
or improper care may degrade battery performance, cause irreversible damage or fire to the battery or connected equipment.
Warning !
Ensure that the electrical cables are always in good condition: Do not allow them to become tightly knotted, crushed or
pinched. Damaged cabling may cause critical failures, electric short or fire damage.
Never
fly with damaged parts.
Warning !
Do not exceed the maximum take-off weight, this may apply undue stresses on the airframe, create instability, cause damage
or wear to equipment.
Warning !
If any batteries or accessory equipment is fitted to the Hexacopter (including parts for FPV configuration) you must fit the
items closest to the centre of gravity to minimise any imbalance and to not exceed the maximum total weight of 3.0kg.
Warning !
Moisture can cause damage to electronics. This equipment not specifically designed and protected for water exposure so it
should be avoided.
Warning !
Always reduce the throttle when collision, crash or rotor strike to prevent further damage to rotors, motors or other items.
Warning !
Some Flight modes need to be disabled in the event of a collision, crash or rotor strike to allow the rotor to be completely
stopped.
Warning !
This product should be re-calibrated after any collision, crash or configuration change to the accessories fitted effecting the
weight distribution or magnetic field to the compass.
Warning !
Always keep moving parts clean. Always let parts cool after use before touching. Always keep clear of moving parts.
Warning !
Always keep aircraft in sight and under control. Always operate UAV in open spaces away with appropriate separation
distance from people, vehicles, animals and structures according to guidelines and regulations set by CASA.
Safety Notice
