Control Remoto Inteligente Universal
4
Battery Installation
This remote control needs 2 AAA batteries to work with.
Fresh Alkaline batteries are recommended. To install the
batteries:
1. Turn the remote back, and lift the battery cover off.
2. Insert the batteries, matching the batteries to the (+) and
(-) marks inside the battery compartment.
3. Slide the battery cover back into place.
All data you have set up into the unit will be stored in
memory even you take off the batteries, but you may need
to set the clock again.
Set Up
A. Set up by Brand Code:
1. Switch on the device, which you would like to control
(e.g. TV set).
2. In the back section of this manual, find the brand name
and code no of your device brand (e.g. SONY 001, 004,
017 …).
Note: the codes must be in the column for the
corresponding device group (TV).
3. Hold down the
SET
key and actuate the device key
(e.g.
TV
) at the same time. The TV device key on your
remote control lights up, that means it is in the setting up
mode.
4.You must now enter the
3-digit device code
(e.g. 001
for SONY TV) within 10 seconds. If no entry within 10
seconds, the setting up mode is automatically terminated.
5.The LED goes out if the code has been accepted by the
remote control. If the LED flashes twice, that means the
code may be wrong, and the remote control remains in
set-up mode, you should enter the correct code from the
list again in time.
