Control Remoto Inteligente Universal
6
control. If all the keys do not function (that means you
may not stop the search in time), or most keys’ operation
is not good enough, you can start the search again (see
steps 2–4) to find a suitable code.
If most key’s function properly, that means your set up is
successful, press the device key (e.g. TV) again to save
the code and finish the set up.
Remark:
1.To abort the “Automatic Search”, press any key (except
set key). The LED lamp will go out and the search is
terminated.
2. The “Automatic Search” will be terminated
automatically after it goes through all codes and LED will
light off. But you can start it again if necessary.
C.
Setting up by Manual Search:
If setting up with brand name and codes is unsuccessful,
you can also use the “Manual Search” to find the correct
code for operating your device.
1.Switch on the device that you like to control. If it is a
video recorder, insert a video cassette.
2.Point the remote control at your device. Press down and
hold the SET key and press the device key (e.g. TV) in a
short time (less than 3 seconds, otherwise it goes to
Automatic Search), then release the both pressed keys.
3.The device key lights up continuously and the remote
control is then in setting-up mode.
4.Actuate the POWER key (ON/OFF key) about every 1.5
seconds. (If the device being sought is a video recorder,
DVD player, CD player, AUX etc., you can press the
PLAY button also.), the device button now flashes, that
means it is in Manual Search mode.
5.Once the searched device switches off (or react), test
the functions of other keys (don’t press POWER key, in
case it goes to next code) on the remote control. If most of
them do not function properly, press the POWER key
