Control Remoto Inteligente Universal
8
4. Press and hold the source button on your original
remote control (e.g.POWER) until the LED on your new
remote control blinks 3 times and lights up 1 seconds,
then blinks again. (That means you have learnt POWER
singnal from the original remote,and you new remote
control is in learning again for next learning.)
If there is a learning problem, the light blinks 4 times and
lights up for 2 seconds then blinks, (That means you
failed to learn POWER singnal from the original remote,
and you new remote control is in learning again for next
learning.)
5. Repeat Steps 2 to 4 to learn more bottons.
Remark:
1. If you want exit the learning mode, Press and release
LEARN key.
2. In learning mode you must not be more than 30 mm
between 2 remotes., and the 2 remotes must be put in a
straight line.
3. It will eixt the learning mode if you don’t press any
keys in 10 seconds .
4. You can press SET and 4 together to delete all buttons
you have learnt under the device button, the LED
will flash 2 times to confirm it.(First choose the device
button which you like to delete)
5. If the memory is full, LED blink 4 times then quit for
learnning.
6. The last learnt singal will overwrite the previous signal.
