SE10 Manual
7
Selectronic Australia
System Wiring
Your SE10 may form part of a complete power system, If this is the case, the
diagram on page 6 may give you a guide. See your designer / installer for full
details.
Electrician’s Note
•
All earth’s AC and DC should be bonded
•
An Earth stake should be within 3m of the inverter
•
The SE10 is suitable for connection to MEN wiring
Warning
As a matter of safety, Selectronic strongly recommend that all fixed
installations be designed and installed by appropriately qualified person. The Solar
Energy Industries Association in your state or territory can provide names of accredited
system designers and installers.
All AC wiring MUST be carried out by an accredited electrician and must conform to
AS3000 and/or any relevant local standards.
The output voltage from an inverter is as lethal as mains electricity.
Getting Started Quickly
If you want to get powered up quickly here are the 11 simple steps.
1.
Familiarise yourself with the details in the first 6 pages on this manual.
2.
Unpack the SE10 from the packaging.
3.
Check unit for any damage that may have resulted during transport, if
any damage is evident report this to your supplier immediately.
4.
Make sure the SE10 ON/OFF switch (12) is in the off position.
5.
Connect battery positive wire (red) (10) to battery positive or battery
fuse.
6.
Connect battery neg. wire (black) (11) to battery negative or battery fuse.
7.
Plug a 230 - 240V appliance into inverter front power point (8) but do
not switch on.
8.
Turn ON/OFF switch (12) to ON.
9.
After 3 seconds LED (1) will begin to flash. If no LEDs light, check for
correct connection to battery.
10.
Turn power point (8) on
11.
You’re away.
