LD200 Manual
Selectronic Australia
12
LD200 12 Volt Specifications
Inverter Type
Microprocessor control circuit with PWM full bridge power
stage. True sine wave AC output.
Current draw from Battery
Condition
Amperage
Inverter ON, with no Load
Maximum Continuous Load (200 Watt)
Surge rating (600 Watt)
0.30 Amps
20.0 Amps
55 Amps
Inverter Power Ratings @ 25
º
C
Total Inverter output
Condition
Wattage @ 1.0pf
Current
Continuous
Half hour rating
Surge rating (3 seconds)
200 Watt
250 Watt
600 Watt
0.83 Amps
1.04 Amps
2.0 Amps
Battery Voltage Range
Voltage
Low DC Volts Cut Out–10 second delay
Low DC Volts Cut In
High DC Volts Cut Out–Instantaneous
11 volts
12 volts
17 volts
Miscellaneous Specifications
Reverse Polarity Protection
Output Voltage Accuracy 0-200 watts
Output Frequency
Total Harmonic Distortion
Operating Temperature Range
Socket Outlet
Chassis
Full Electronic Protection
± 4% @ 12 volt input
50Hz ± 0.01%
<4%
-10º C to 50º C
10 Amp Single Pole
Powder Coated Zinc Steel
LD200 Manual
Selectronic Australia
1
Introduction
Thank you for choosing to purchase the Selectronic LD200 True Sine
Wave Inverter. Many hours of Research and Development have gone
into the LD200 to ensure this inverter provides you with many years of
reliable service
Warranty Card
It is imperative that you complete your warranty card NOW. Your LD200
is covered by a TWO year warranty; this warranty is in addition to your
rights under the trade practices act of your state or territory.
Returning your completed warranty card will register your warranty and
avoid any possible delays should service be required. If you have any
comments about our product that will not fit on the warranty card please
feel free to drop us a line. Yes, constructive criticism will also be welcome.
Installation
200mm
200mm
200mm
LD200
Inverter
Front
200mm
LD200 Inverter
Please leave a clearance of 200mm on all sides and top of the Inverter.
The LD200 must be installed in a dry, cool, dust-free environment.
It is recommended that the inverter be placed as far from any radio
receivers as possible.
