LD200 Manual
Selectronic Australia
2
Large amounts of DC current can be drawn by your LD200,
care
must be taken.
Fixed Installation
All fixed installation battery connections must be securely bolted,
using stainless steel nuts and bolts. To protect the connection from
corrosion smear a small amount of Vaseline or similar over the
joint. Never place batteries directly onto a concrete floor, place
timber or similar material beneath the batteries.
Electricians Note
•
All Earths, AC and DC, should be bonded
•
RFI/Lightning Earth stake should be within 3m of the inverter
•
The LD200 is suitable for connection to MEN wiring
•
Any AC changeover switch must be a ‘break before make’ type
Warning
As a matter of safety, Selectronic strongly recommend that all fixed
installations be designed and installed by appropriately qualified person. The Business
Council for Sustainable Energy in your state or territory can provide names of
accredited system designers and installers.
All AC wiring MUST be carried out by an accredited electrician and must conform to
AS3000 and/or any relevant local standards.
The output voltage from an inverter is as lethal as mains electricity.
LD200 Manual
Selectronic Australia
11
Product Warranty Conditions
Warranty
Selectronic Australia Pty Ltd warrants your inverter to be free from
defects in materials and workmanship under normal use and
service, for an initial period of two (2) years. Defective parts will
be replaced or repaired free of charge within this period.
Conditions
This warranty is applicable only from the date of original purchase.
The provision of this warranty shall not apply if the unit has been
subject to misuse, neglect, act of God, accidental damage or has
been used for a purpose for which it is not intended.
Unauthorised modification or repair will void your warranty.
To ensure a smooth and speedy response to your warranty claim,
please complete and return your reply paid warranty card within 30
days from date of purchase.
Within Australia & New Zealand
The inverter must be returned, at the owner’s cost, to an authorised
service centre listed in this manual. There will be no charge for the
return of the inverter.
Outside Australia & New Zealand
Product purchased for use outside Australia & New Zealand must
be returned to Selectronic Australia’s Service Centre to enable
warranty claims to be processed. Freight cost to be borne by the
customer. No charge will be made for the product return.
