LD700-24 Manual
Selectronic Australia
10
Low Volts Adjust LED (5) (green) FLASHING
To avoid total discharging of your battery the LD700-24 shuts down at a pre-
set low voltage. As all batteries are different, so too is the minimum voltage
they should be discharged to. The LD700-24 will leave the factory with a
setting of
22.0 volts
, change this setting if required.
Hold the Mode button (7) down until LED (5) is FLASHING, (approximately
2 seconds) indicating you are ready to adjust this setting. Now press the
Mode button (7) until the desired value is sought. LEDs (1) – (4) will return
to Status after 20 seconds.
Low Volts
Cut-out
LED 1
LED 2
LED 3
LED 4
20.0 Volts
20.2 Volts
20.4 Volts
20.6 Volts
20.8 Volts
Slow Flash
Medium Flash
Fast Flash
Fastest Flash
ON
ON
ON
ON
ON
21.0 Volts
21.2 Volts
21.4 Volts
21.6 Volts
21.8 Volts
Slow Flash
Medium Flash
Fast Flash
Fastest Flash
ON
ON
ON
ON
ON
22.0 Volts
22.2 Volts
22.4 Volts
22.6 Volts
22.8 Volts
Slow Flash
Medium Flash
Fast Flash
Fastest Flash
ON
ON
ON
ON
ON
23.0 Volts
ON
After “23.0 Volts”, the next button press “rolls back” the Low DC Volts
Cut-out setting to “20.0 Volts”
