Selkirk DIRECT-TEMP 4DT-CCK Installation Instructions Download

Page: 4 / 4

Fig 7

Fig 8

Fig 9

Fig 10

5030 Corporate Exchange Blvd., SE, Grand Rapids, MI 49512 1-800-992 VENT (8368)

Cut and Bend Flashing
as Appropriate to Fit
Chimney

Termination Cap

Chimney Outlet
Connector

3 Sheet Metal
Screws Here

Flashing

Chimney Inlet
Connector

6” Diameter Hole
in Masonry Wall

Chimney Inlet
Connector

Fig 11

Masonry Chimney
Studwall

10” x 10” Framed
Opening in Wall

Chimney Inlet
Connector

Mastic Sealant
Here

0015206 - 0712

Summary of Contents for DIRECT-TEMP 4DT-CCK

Page 1: ...Y BUILT AND MASONRY CHIMNEYS CONVERSION TO A FACTORY BUILT METAL CHIMNEY 1 Remove the existing chimney cap 2 Measure the distance from the top end of the chimney to the bottom of the ceiling support a...

Page 2: ...nector Existing Metal Chimney System Flex Pipe Chimney Inlet Connector Adapts to Support Any DT Black Direct Vent Pipe Fig 1 Fig 2 Fig 3 Fig 4 Chimney Outlet Con nector Sheet metal Screws Here Chimney...

Page 3: ...from the center of the chimney to out through the wall Cut a piece of 4 inch flex to this length the flex should already be extended to its nominal length 5 Connect the 4 inch flex liner to the Chimne...

Page 4: ...lashing as Appropriate to Fit Chimney Termination Cap Chimney Outlet Connector 3 Sheet Metal Screws Here Flashing Chimney Inlet Connector 6 Diameter Hole in Masonry Wall Chimney Inlet Connector Fig 11...

Brands by name