DT-E 1.1: SUN PROTECTION SCREEN – VENETIAN BLINDS C50 Slim
Issue 2 / April 2017 / EN
page 21 / 25
7.
GENERAL WARRANTY CON DITIONS
General warranty conditions are available on
http://www.selt.com/doc-en
In case of no access to the SELT website, the warranty conditions can be obtained from the sales representative of
SELT Sp. z o. o.
7.1.
EXCLUSIONS FOR WARRA NTY
Warranty does not cover:
Damages resulting from transport other than SELT,
Damages resulting from storage, installation or maintenance activities other than described in the technical and
operational documentation or Supplier recommendations, unless those activities were conducted or advised by
the Supplier,
Damages resulting from failure to observe Supplier recommendations contained in the technical and operational
documentation of the product,
Mechanical damages,
Damages resulting from self-modifications conducted by the user, unless it was done by the Supplier, or on behalf
of the Supplier, or with its written permission,
Secondary damages resulting from using the product regardless of the noticed faults, unless the Supplier was
notified about it and recommended further use. The assessment of damage causes is left to the rational
recognition of the Supplier. Repair or change of the product due to the damages described herein can be done by
the Supplier against payment.
Faults resulting from normal wear of product parts, including: seals, lubricants, etc.,
Repairs involving regulation, cleaning and lubrication,
Electrical devices delivered to the Supplier in a manner not allowing for operation check (e.g. cut off motor cable,
receiver in parts),
Damages of electrical origin as a result of user fault,
Damages resulting from incorrect installation of the product unless it was done by the Supplier, or on behalf of
the Supplier, self-repairs and adjustments,
Damages resulting from incorrect cleaning with the use of caustic and grinding products or inappropriate devices.
Atmospheric and phytosanitary pollution
Effects resulting from hanging on the blind other products or objects, that are not related to Selt systems.
Damages resulting from using the product in incorrect weather conditions,
Uneven tilting of one or more of the blinds in case of modular installation with one motor (non-collinear
operation of the blinds within one module),
Uneven tilt of the slats between particular modules installed on one facade, for modules driven with separate
motors and common operation. The difference between tilt might be up to 30
and cause visible effect of uneven
position of slats in particular modules,
„Arrow effect” which can appear in narrow and high venetian blinds, when during rolling up the ladder string gets
between the slats causing the bundle to appear thicker on one side,
Bottom bar deflection in case of very wide blinds,
Incomplete closure of lower slats in case of very high venetian blinds. This does not cause the incorrect operation
of the product,
Asymmetrical behavior of elements cooperating within one venetian blind or module (e.g. bottom bar) due to
manufacturer’s production tolerances and physical properties of textiles used.
