DT-E 1.4: SUN PROTECTION SCREEN – VENETIAN BLINDS Z90
Issue 2 / April 2017 / EN
page 35 / 58
5.
Measure the distance from the bottom of head rail to
the underneath of bottom bar (of the rolled up blind).
Picture 4
6.
From the guide rail cut off a length measured in Step 5.
Follow the step for the second guide rail.
ATTENTION:
In the bottom part of guide rail the edges
that guide the gasket are kneaded. The section of guide
rail that is cut off should be cut from the upper part of
the rail.
Picture 5
7.
Section of the cut off guide rail install in the upper part of
mounting profile, using tapping or self-drilling screw, as
shown in Fig. 4. The head of the screw should not block
pins in the slats. Follow the step for both guide rails.
Attention:
in case of using tapping screws it is
recommended to pre-drill guide rail and mounting profile
accordingly to diameter of the used screw.
Picture 6
Fig. 4
8.
Put the bundle of slats with head rail within the
mounting profiles (for convenience of installation put the
bundle at slight angle, so the pins are not damaged)
9.
Lift the bundle to the top to install the head rail in its
brackets. You should pay special attention to properly
insert the pins in cavity of the guide rail (mounted in top
part of the mounting profile).
Picture 7
