DT-E 1.4: SUN PROTECTION SCREEN – VENETIAN BLINDS Z90
Issue 2 / April 2017 / EN
page 38 / 58
Installation of Venetian Blind with window frame guide rail.
Before commencing the installation of Venetian Blind it is necessary to measure and mark the placement of main brackets
for cover panel in such place so that they do not collide afterwards with rolling mechanisms and motor.
Join the main bracket with auxiliary bracket loosely. Measure them to cover panel, adjust to its height and secure tightly.
Img. 1
b)
Installation
1.
Connect head rail bracket to the main bracket.
Measure to the cover panel, adjust and secure tightly.
Img. 1
NOTE:
For installation on window frame in the rear
part of cover panels type 2, 4 and 4a it is necessary to
cut on the left and right side small piece to enable the
installation of guide rail. The cut should be done
according to scheme from fig. 7.
Fig. 7
2.
Fasten to wall or niche the set of brackets with cover
panels.
3.
Tighten main brackets to wall/ceiling.
Img. 2
4.
Check the level of installed covers with brackets,
correct if necessary. Correct leveling of the system is
necessary for its correct operation.
Img. 3
