Alyseo 106
SELTA S.p.A
.
All rights reserved. No parts of this document can be reproduced, memorized into archive system or transmitted
in any shape or through any means without the previous authorization of SELTA S.p.A.
4-16 Configuration
Interface
Alyseo 106 User Manual
720041008-A0-GB Issue 4
Traffic
With this configuration, it is possible to disable the control of the traffic on the Frame Relay
interface. If disabled, the traffic is not ‘tagged’ or discarded until the limit of available physic band.
Alyseo106 fr port conf > traffic
enable Enable FR traffic control
disable Disable FR traffic control
Endpoint
Typing "endpoint <DLCI>", that is the value of DLCI Frame Relay (Data Link Connection
Identifier), it is possible to create a new FR connection and configure it, or to modify an existing
one.
If a non-existing value of DLCI is inserted, CLI asks for confirmation before creating it, type "y" or
"yes" to confirm.
Ex:
Alyseo106 fr conf > endpoint (‘?’)
16-1007 dlci value
Alyseo106 fr conf > endpoint 200
dlci not exist
Insert new DLCI, yes or no? yes
DLCI 200 inserted
This command has changed level and new available commands are:
Alyseo106 fr endpoint conf > (‘?’)
cir
committed information rate
bc
committed burst size
be
excess burst size
switching Dlci
switching in Network mode (ingnored in Service mode)
show
show End Point FR configuration
done
Done Frame Relay End Point configuration
When a new DLCI is inserted, new entries in Database are created, to remove them use the
command "no" shown later.
Alyseo106 fr endpoint conf > cir (‘?’)
1-2147483647 bit/sec
Alyseo106 fr endpoint conf > bc (‘?’)
1-16384 byte
Summary of Contents for Alyseo 106
Page 1: ...User Manual Alyseo 106 ...
