Alyseo 106
SELTA S.p.A
.
All rights reserved. No parts of this document can be reproduced, memorized into archive system or transmitted
in any shape or through any means without the previous authorization of SELTA S.p.A.
Configuration Interface
4-17
Alyseo 106 User Manual
720041008-A0-GB Issue 4
Alyseo106 fr endpoint conf > be (‘?’)
1-16384 byte
With the following configuration, it is possible to enable the translation of the DLCI of the frame
relay header on a different DLCI to the header of FR-SSCS, when it is transported on ATM:
Alyseo106 fr endpoint conf > switching
dlci Enable Dlci switching
off Disable Dlci switching
Alyseo106 fr endpoint conf > done
typing "?" we obtain
Alyseo106 fr conf > ?
port
configure Frame Relay port
endpoint
configure Frame Relay End Point Usage: endpoint <dlci>
lmi
LMI (Local Management Interfaces) parameter
show
Show Frame Relay Configuration
done
Done Frame Relay configuration
LMI
LMI item opens a submenu dedicated to signaling of Frame Relay:
typing "LMI" and, as we did before, "?" the following submenu opens:
Alyseo106 fr lmi > (‘?’)
procedure
local in-channel signaling procedural role
type
Signaling
Protocol
N391
full status polling cycle value
N392
error threshold value
N393
monitored events count value
T391
link integrity verification polling timer value
T392
polling verification timer value
show
show LMI parameter
done
done FR LMI configuration
procedure
It identifies the rules applied for the signaling and contains three specific commands:
- uni_net
the logic port applies the "user to network" rules seen by network side.
- bidirectional
the logic port applies the rules in bi-directional way.
- uni_user
the logic port applies the "user to network" rules seen by user side.
type
It allows selecting the proper Frame Relay signaling protocol, according the following choice.
Alyseo106 fr lmi > type
Summary of Contents for Alyseo 106
Page 1: ...User Manual Alyseo 106 ...
