User Manual BC300
STORAGE OF DATA USING USB MEMORY_
53
STORAGE OF DATA USING USB MEMORY
Storage of data
Select of FLASH MEMORY
1)
Insert USB memory stick into USB(A) jack placed on the back side of the device.
2)
The following message appears.
‘Do you want to write data to USB memory stick?
’
on initial screen. Press
‘
YES
’
to send to USB memory.
3)
Transmitting message will be displayed on the screen. When transmission is completed, the message
‘The data writing was completed’ will be shown. Press CLOSE to complete the saving process.
Select of USB MEMORY
When select
‘
USB MEMORY
’
, measurement data will be stored at USB MEMORY without notification.
Summary of Contents for ACCUNIQ BC300
Page 1: ...English 06 2021 V3 01 User Manual BC300...
Page 71: ......
