OPERATING PROCEDURES
Automatic Operation
Procedure
Display
Turn on the breaker and press the upper
part of START key of the shredder. The
SHRED READY screen appears.
Note: If idle for more than 5 minutes, it
Goes into the power save mode and
all power goes off. Press the upper
part of the START key again to
restore.
Feed the paper straightforward into the
throat opening by aligning the center part
to the
AUTO START
mark. When paper is
drawing into the shredder, remove your
hands immediately.
Shredding volume is displayed in 4 levels
as shown in the right.
ϖ
It is recommended to shred the
paper with the volume of (a) to (c)
levels.
ϖ
If the paper to be shredded
exceeds the level (d), auto-reverse
function may work.
Note: Shred levels vary depending on the
paper quality and/or voltage fluctuation, so
take these levels as a reference.
After using the shredder, turn OFF the
main breaker and pull out the plug from the
outlet.
For NATIONWIDE SERVICE call 1(800)225-9293
13
https://www.supplychimp.com
