LUBRICATION
ALWAYS
lock off power before cleaning, lubricating, maintaining, removal of
any guard, and after shredding operation is complete.
Daily lubrication: (After 8 hours of operation).
o
Machines equipped with auto cutter lube, depress Cutter Lube button
momentarily while machine is running and allow machine to run empty
for approximately 4 minutes.
o
Check oil level in auto cutter lube reservoir. (Level can be seen
through a slot in guard just below the fill tube.)
o
Machines not equipped with auto cutter lube follow the steps listed
below.
o
Remove top guards
o
Apply light machine oil to cutters.
o
Replace all guards.
Weekly lubrication: (After each 40 hours of operation).
o
Repeat steps from daily lubrication.
o
Remove guards
o
Apply oil to drive chains (see fig. 2, page 20) Use chain and cable
lubricant.
o
Replace all guards.
o
Fill auto cutter lube reservoir with SAE 20W Non-Detergent oil. (For
machines equipped with auto cutter lube only).
Monthly lubrication: (After each 173 hours of operation).
o
Repeat steps from weekly lubrication.
o
Remove guards
o
Check reducer oil level by loosening the top jam nut and adjusting nut
on torque rod enough to pivot the reducer to the horizontal position
(see fig. 3, page 21). Remove level plug. Oil will run out if filled to
13
Summary of Contents for 800-1000 Series
