o
To adjust belts, loosen the jam nuts (both top and bottom) and the
lower lock nut on the reducer torque arm
o
Turn the upper lock nut until proper tension is achieved
o
Re-tighten lower lock nut and both jam nuts
o
Replace all guards
NOTE:
Purchase of Dodge V-belt tester, Model #109082 is recommended.
CHAIN SAG
Chain drives have fixed centers and are not equipped with either take-ups or
adjusting features. (Chain sag is permissible within the limits shown on fig.
6, page 24).
Chain sag distances may be measured by placing a straight edge across the
two sprockets being checked.
o
Lock power off.
o
Remove access guard
o
Check chain sag according to figure 5, page 23
o
Loosen two bolts on idler sprocket, and slide toward the chain only
enough to take up sag
o
Replace chain if stretched beyond the limits shown in figure 5
o
Retighten bolts on take-ups
o
Replace all guards
17
Summary of Contents for 800-1000 Series
