20
System parameters -- # 2 of 6
This menu leads you to the different parameters you need to program in
your Vend Station. Those apply to the entire operation no matter the type of
copier connected to your system. Some menus may not be visible depend-
ing if it refers to a peripheral not detected on power up.
Set clock
Set time and date on your Vend Station. This information will appear at the
top of any printed audit. The Vend Station uses the international (or military)
time format. 8PM = 20:00. The date is also in the international YYYY/MO/
DA format. Please note that your Vend Station WILL NOT adapt to daylight
saving time automatically.
Serial reader
When a serial magnetic card reader is present, you will have additional pa-
rameters to program. They are:
Decimals after the dot
Site code 1
Site code 2
Site code 3
STX code
ROM code
Card type
Decimals after the dot
You can select to show two or three digits after the decimal point. Select
three digits if you charge a price including tenth of cents (i.e. 6,4¢ per copy)
for the prepaid card.
Does not apply to CC reader.
Site codes 1, 2, and 3
Enter here the three site codes you wish to accept. A site code is the signa-
ture of the card for a specific location. If you are not using all site codes,
enter the site number for those not in use. (i.e. site code 1 = 0164; site code
2 = 0002; site code 3 = 0003).
If you enter an identical site code more than once, the system will have prob-
lems dispatching the sales to the proper site code in the audit.
STX and ROM codes
The STX and ROM codes are important. They are a part of the identity of
your card system. On the SET PARAMETERS cards you received with the
Summary of Contents for 9900X
Page 1: ...www sem ca April 2017 Part i01081 Version 3 7...
Page 36: ...36...
