Kingfisher Plus+ Hardware Manual
Backplane Power Header J14
Only two rails (24V and 0V) are required to be connected for time synchronisation between
backplanes to work.
The following cables can be ordered from Semaphore to provide required connections:
•
BPC-01 or BPC-02 Backplane Power Cables.
WARNING. All power rails of the connected backplanes will be connected as well.
•
BPC-02-GPS time synchronisation cable.
•
BPC-SPLIT splitter cable if more than two backplanes need to be connected.
The DI-10-GPS has an RJ-45 jack for direct connection of a Garmin GPS16x-HVS device. It
is located directly underneath the LED display of the DI-10-GPS module.
The Garmin GPS16x-HVS can be ordered from Semaphore directly or via many commercial
outlets.
RJ45 Jack for GPS device
RJ-45 pin-out and wire colours of the Garmin GPS16x-HVS are shown on the DI-10 v4.3
block-diagram. If a different model of GPS device is to be used, an adapter should be
constructed using signal information in the table below.
Hardware Manual Version 7.16
http://www.servelec-semaphore.com/
Page 160
