Kingfisher Plus+ Hardware Manual
Backplane Connectors
There are several connectors located at the right-hand side of the Kingfisher Plus+
backplanes which are used for wiring power and/or signals outside of a backplane. The type
and quantity of the connectors depend on the model of the backplane. Please refer to the
pictures of the backplanes shown earlier in this chapter and/or the connector reference
designators to determine which connectors exist on your backplane. All connectors are
described in the table below.
Designator
Connector Type
Connector Pinout
J14
6-pin 4.2 mm male header (white).
Molex P/N 39-28-8060
(mating part P/N 39-01-2065).
Note: the ‘24V’ pin may be used for
other purposes such as time-
synchronisation between backplanes.
J13, J15*
7-pin 3.5 mm male header (green).
Phoenix P/N 1843651
(mating part P/N 1840418).
J6
9-pin 5.08 mm male header (orange).
Weidmuller P/N 1520260000
(mating part P/N 1716390000).
J5
4-pin 3.5 mm male header (green).
Phoenix P/N 1843622
(mating part P/N 1840382).
* - J15 for BA-x-PLUS backplanes only; not present on BP-x-PLUS units.
It is recommended to cover all unused backplane connectors in harsh environmental
conditions (e.g. by fitting the mating connector). The parts suitable for the Power and Data
connectors are listed in the table above. The suitable mating parts for the 32-pin module slot
connectors are listed below:
1. Oupiin P/Ns: 9001-3532 / 9001-3520 / 9001-3732 / 9001-3720.
2. Harting P/Ns: 09 22 132 7922 / 09 22 132 6922 / 09 22 132 2922 / 09 22 132 7921 /
09 22 132 6921 / 09 22 132 2921.
Hardware Manual Version 7.16
http://www.servelec-semaphore.com/
Page 27