Raise the presser bar (a) with the presser foot lifter. Attach the
presser foot shank (b) as illustrated. (1)
Install the pin (d) of the presser foot (e) into the cut-out (c) of
the presser foot holder. (2)
Push the presser foot (e) to disengage from the cut-out (c). (3)
Attach the edge/quilting guide (f) in the slot as illustrated. Adjust
as needed for hems, pleats, quilting, etc. (4)
Turn power switch to off ("O") when carrying out any of the
above operations!
Attaching the presser foot
Removing the presser foot
Attaching the edge/quilting guide
Attention:
Attaching the presser foot holder
1
3
2
4
e
c
f
a
c
d
e
b
a
b
8