20
configuration should be completed. Make sure that each Parani-
ESD‟s connect LED is on. At this
point, when both Parani-
ESD‟s are restarted the connection will be established automatically.
3.8. ParaniWizard
ParaniWizard is a Wizard program that will allow you to configure a pair of Parani-
ESD‟s for an
automatic connection. To make connection with Bluetooth devices other than Parani-ESD, use
ParaniWIN or AT commands on a terminal program.
In this example, we will refer to the two Parani-
ESD‟s as ESD1 and ESD2 respectively.
Install and run ParaniWizard.
Figure 3-10 ParaniWizard Step 1
Plug ESD1 into the serial port of the host computer and power on the unit. Click [Wizard Setting]
button to configure the serial port settings of ESD1. These settings must be the same as those of the
host system, to which ESD1 will be used. Click [Next].
Figure 3-11 ParaniWizard Step 2
Summary of Contents for Parani-ESD100V2
