29
Getting Started
Base Station Installation
1. Install base station antenna.
Note
:
The base station’s antenna port has a reverse-
thread connector; to install antenna or cable, turn
counter-clockwise; to remove, turn clockwise.
Improper installation may damage the connector.
2. Plug the transformer end of the base station AC/DC
adaptor into a standard AC electrical power outlet,
plug the other end into the “DC In” jack on the back
of the base station.
Note:
1. The base adaptor’s DC plug is larger in dimension
than the charger’s DC plug. The charger adaptor’s
DC plug will not fit into the base’s DC In jack.
2. The base station’s power supply (DC Adaptor) and
telephone line should be plugged into a surge
protector with phone line protection.
3. It is recommended to use an UPS (Uninterruptible
Power Supply) to prevent lost of telephone services
in a power outage.
3. Plug one end of the phone cord into one of the 4
phone jacks marked L1 – L4, starting from L1, plug
the other end into the telephone outlet.
4. Repeat for additional phone lines. You can add
phone lines at later times.